PCB Signal Mounting Update

I have designed PCB signals in various types, which I will be selling to others, but the genesis for this idea was the fact that I needed signals on the removable bridge sections of the layout.

I didn't want to risk expensive scale signals (at $25 to 48 each) on something that will get moved and placed at ground level, hence using signals that are just made out of circuit board.

Mounting them takes a 3/4" hole made with a forstner bit giving you a flat bottom hole.

The PCB is a bit smaller than 3/4, so you need a way to hold them in.

A piece of strip styrene and 2, #4 by 1/2" screws, and done!